Installation
A1-1
E 2000 Nordson Corporation
All rights reserved
41-3000V
Issued 5/00
A3EN-04-[3V-A-AAXP]-12
Section A 1
Installation
WARNING: Allow only qualified personnel to perform the
following tasks. Follow the safety instructions in this document
and all other related documentation.
This section of the manual describes how to
S install the unit, hoses, and guns
S program system settings
S prepare the unit for operation
If you have purchased optional features with your unit, such as a
low-level indicator or an input/output (I/O) board, refer to the Options
section of this manual for installation instructions.
Besides using normal care, you need no special instructions to unpack
the unit or the equipment you purchased with it. All hoses and guns are
shipped in separate packages.
After unpacking the equipment, inspect it for any damage that may have
occurred during shipping. Look for dents and scratches and make sure
all fasteners are tight. Report any damage to your Nordson
representative.
This part of the installation section gives you the installation requirements
and recommendations that you need to know before installing your unit.
It includes
S Location Requirements
S Wiring Requirements
S Hose/Gun Power Requirements
Other requirements and recommendations are provided in the installation
procedures when they are needed.
1. Introduction
. Unpacking
. Inspection
. Installation
Requirements
To Next Page
Loading...
Need help?
General
