Nordson 3100V Series User Manual

Installation
A1-66
E 2000 Nordson Corporation
All rights reserved
41-3000V
Issued 5/00
A3EN-04-[3V-A-AAXP]-12
5. Record the pattern set you stored on the form provided at the end of
this section. Refer to Records of System Settings.
NOTE: The form provides space to record up to 25 pattern sets.
After you have programmed two or three pattern sets, it is faster to
program and store a new pattern set by changing an existing one. Use
this procedure to create a new pattern set by changing an existing
pattern s et.
1. If necessary, change your line speed setting. Refer to the procedure
To Enter a Line Speed in this section.
2. Press the Move Up key in the System Settings area until the light next
to the pattern you want to change (output 1 or output 2) turns on.
3. Press the Move Right key to select the bead start or end point to
change. The current value for the point is shown in the Multipurpose
display.
4. Use the Up and Down keys to change the setting in the Multipurpose
display. The Multipurpose display flashes.
NOTE: The first time you change any information about this pattern,
the number in the Selector display disappears to indicate that the
pattern is being changed.
5. Press the Enter key to accept the new setting. The number in the
Multipurpose display stops flashing.
6. Repeat steps 3--5 until you have changed all the settings you need to
change.
7. Repeat steps 2--6 to change the bead start and end points for the
other output.
8. Store the patterns you just changed as a new pattern set. Refer to
Storing a Pattern Set in this section.
NOTE: The pattern set you used to create the new pattern set will
remain unchanged in the controller’s memory.
S
t
o
r
i
n
ga
P
a
t
t
e
r
n
Se
t
(contd.)
C
r
ea
t
i
n
ga
N
e
w
P
a
t
t
e
r
n
Se
t
f
r
o
m
a
n
E
x
i
s
t
i
n
g
P
a
t
t
e
r
n
Se
t

Nordson 3100V Series Specifications

General

Brand	Nordson
Model	3100V Series
Category	Melting Machines
Language	English