- 185 -
10. Management/Specifications
1
Press [Device Settings] on the touch panel.
2
Press or several times and press [Admin Setup].
3
Enter the administrator name and password and press [OK].
The factory default administrator name and password are "admin" and "999999"
respectively.
4
Press or several times and press [Management].
5
Press [Power Save].
6
Press [Sleep Time].
7
Select transition time.
The machine does not enter Sleep mode in the following cases.
• When an error occurs on the machine
• When a delayed fax transmission is set
• When a fax transmission is waiting for redialing
The machine does not enter Deep Sleep mode in the following cases.
• IPSec is enabled
• A TCP connection is established
Example: A connection is established with Telnet or FTP.
When the transition time to enter Sleep mode or Deep Sleep mode from Power Save
mode elapses and the connection is disconnected, the machine enters Sleep mode.
• E-mail reception is enabled
• Wireless LAN is enabled
• Google Cloud Print is enabled
• LLTD is enabled
• HUB Link Status is 1000BASE-T
• IPv6 Global Address is assigned
• Access Control in the Access Control settings is enabled and Local IC Card or LDAP IC
Card in the Authentication Method is enabled.
To switch the machine to Deep Sleep mode, disable IPSec or e-mail reception.
In Deep Sleep mode, you cannot use the following protocols to print.
•IPv6
•NBT
• WSDPrint
In Deep Sleep mode, you cannot search or set by using the following functions and
protocols.
•NBT
•PnP-X
•UPnP
Setting the Length of Idle Time Before Entering Sleep Mode Restrictions in Power Saving Function
To Next Page
Loading...
Need help?
General
