Oki ML3410 User Manual

Inserting the Ribbon
Inserting the Ribbon
1. Unpack the ribbon and remove the shipping restraint.
2. Push the idler roller latch in.
3. Lay the ribbon in the printer so that the pins on the cartridge fit into the notches in the side plates
of the printer. Push down on the cartridge until it clicks into place (See the diagram on the
cartridge).
Note
Turn the knob in the direction of the arrow if the cartridge doesn't fit into place easily.
4. Center the printhead.
5. Thread the ribbon around the posts as shown.
6. Turn the take-up knob clockwise to take up the slack in the ribbon.
ML3410 ( 96-02-07 )

Oki ML3410 Specifications

Print Specifications

printhead	9 pin
print speed at 10 cpi	HSD 550 cps, Utility 417 cps, NLQ 104 cps
graphics resolution	1445216 dpi maximum

Paper Handling

paper weight	12 to 24 lb
paper thickness top feed	0.36 mm (0.014 inches) maximum
paper thickness bottom feed	0.50 mm (0.020 inches) maximum

Operating Environment

operating temperature	50 to 104 degrees F (10 to 40 degrees C)
storage temperature	14 to 122 degrees F (-10 to +50 degrees C)
humidity	20 to 80% RH

Electrical Requirements

voltage	120 volts, +5.5%/-15% 220/240 volts, ±10%
frequency	50/60 Hz, ±2 Hz
power idling	30 watts
power operating	75 watts

Weight and Dimensions

width	25-1/4 inches (540 mm)
depth	19 inches (483 mm)
height	15 inches (203 mm)
weight	63 lbs. (25.4 kg)