EN 41
EN
Seal the Case
1 Close the Case gently while aligning the mounting projection of the rear lid and groove.
2 Turn the open/close dial counter clockwise (1 of figure below) until you hear a "click" sound and lock
the Case.
• The Case is sealed.
3 Slide the lock knob towards the LOCK side (2 of figure below).
4 Lower the ON/OFF lever.
Check the operation of the loaded camera
After sealing the Case, check that the camera operations normally.
• Operate the ON/OFF lever on the Case and confirm that the camera turns ON/OFF.
• Turn the mode dial on the Case and confirm that the camera mode switches properly.
• Operate the lever and confirm that the camera lever position switches properly.
• Press the shutter lever on the Case and confirm that the camera shutter releases.
• Operate other control buttons/levers on the Case and confirm that the camera functions properly as
intended.
• If the open/close dial is not fully turned, the Case will not be sealed. This will cause water leakage.
• Close the rear lid of the Case so that the lens cap, silca gel or monitor hood strap doesn’t catch. If it catches,
water leaks may result.
1
2
Close
Open/close dial
Lock knob
PT-EP14_EN.Book 41 ページ ２０１６年７月１４日 木曜日 午後４時３分
To Next Page
Loading...
Need help?
General
