9 RESET
During each wrapping cycle, except for the ones in the MANUAL working mode:
- press RESET to bring the machine to its zero position.
This assures that the cycle operations performed are deleted.
- During this stage, if the RESET switch is pressed again, the
wrapping machine stops and the zero point is set and it is
possible to start the following cycle. A prolonged acoustic signal
is emitted, as in the case of the cycle end.
10 RESTARTING AFTER AN EMERGENCY STOP
Shall it be strictly re
quired to stop the machine, press the
emergency mushroom stop button located in the control panel
(RED button on yellow background). The machine will safely stop
in the shortest possible time.
After pressing the emergency stop button, act in the following way:
- reset the emergency stop button;
- press the RESET button to restore the machine.
When the RESET button is pressed again, the machine reaches its zero position. Once the
repositioning has finished, an acoustic signal is emitted, as at the cycle end.
Press the START button to continue the cycle being carried out before the emergency stop. By
pressing only the START button after the emergency button has been reset, the machine cannot
be restarted.
CRESCO UCP REV10 20
To Next Page
Loading...
Need help?
General
