23 DIAGNOSTIC
The following table describes malfunctions that might occur.
MALFUNCTION
POSSIBLE SOLUTIONS
No electrical power
1. Check that the power plug has been inserted properly.
2. Check that the machine’s main switch is in the ON position.
3. Check that there is voltage in the company power grid.
4. Check the condition of the fuses of the control panel.
5. Contact the manufacturer.
The table turns abnormally
1. Check, and if necessary record the rotation chain tensi
specified in the use and maintenance manual.
2. Check that the limit switches under the table work properly.
3. Contact the manufacturer.
The machine is blocked
1. Check that the programming selector is in the standard position
(yellow led off).
2. Contact the manufacturer.
CRESCO UCP REV10 32
To Next Page
Loading...
Need help?
General
