REGULATION PARAMETERS
The power pre-stretch carriage is regulated independently from the machine. The regulation
parameters of the power pre-stretch carriage are not set through the machine board, but through
the inverter located on the carriage, as shown in the picture. For details on the parameter values,
please refer to the machine’s wiring diagram.
THE INVERTER PARAMETERS MUST ONLY BE CHANGED BY EXPERIENCED STAFF, WITH
A DEEP KNOWLEDGE OF THE MACHINE AND OF THE PARAMETERS MEANING.
WRONG SETTINGS MY LEAD TO MALFUNCTIONS, BLOCKS AND IMPOSSIBILITY TO USE
THE MACHINE.
CRESCO UCP REV10 40
To Next Page
Need help?
General
