rotation is carried out at the reset speed (G17) until the table zero point
e) T
he Start led flashes indicating that the cycle has only been paused and has not been
concluded. The film tension is set as pause tension (G15)
f) Press START to continue the cycle
g) The table starts to rotate at the speed (C4), the film tension start is set (G12) and the delay
start time (G13) is clocked, after which the film tension is set with the stretch value (C3).
The carriage goes up at the speed (C5)
h) From when the pallet is no longer found, the extra length time is clocked (G10)
i)
After the time has elaps
ed, the carriage stops and waits for the completion of the high
revolutions (C2)
j) Once the extra length time has elapsed, the carriage goes down at the speed (C6)
k) Once it arrives at the low limit switch height, it stops waiting from the low revolutions of the
table (C1)
l)
At the end of the wrapping cycle, the machine automatically stops in the unload position of
the product at the reset speed (G17) and the tension of the film is set as tension last
revolution (G14)
REINFORCEMENT
The reinforcement is an additional function, which can be used during a standard cycle, it
is used to reinforce the wrapping of the pallet, keeping the carriage fixed (in the desired
position) and continuing to have the table rotating.
To use the reinforcement, it is necessary to carry out a standard cycle, with for the
carriage to arrive in the desired position and keep the START button pressed. The
carriage stops and the table keeps on turning, the cycle starts again from when the button
is released.
13 CUSTOMIZED CYCLE
The customized cycle is a standard cycle, which, though, has been modified by means of the cycle
parameters buttons. The personalized cycle can be saved in order for it to be re-used several
times in the future.
14 CREATION OF A CUSTOMIZED CYCLE
The user can save nine different customized wrapping cycles.
To perform a cycle customization, it is necessary to:
- Be in Automatic Mode (check that the red led is on AUT).
- Check that the machine is not moving.
- Select the type of Standard cycle to be performed via PRG.
- Modify the cycle parameters by means of the relating buttons.
- Press the Save key, or AUT-MAN-OK and use the buttons + and – to move along the menu.
Once the key is pressed, the machine warns with a double acoustic signal (double beep), then
the command has not been carried out, because this button is deactivated.
CRESCO UCP REV10 24
To Next Page
Loading...
Need help?
General
