Press START to start the selected wrapping cycle.
The available cycles are illustrated here below.
At the end of the wrapping cycle the machine automatically stops in the unload position of the
product. When the machine is working in the standard mode, the cycle should not be manually
stopped. Press the STOP button only if you need to stop the cycle for a particular reason. The
cycle will be suspended. When the START button is pressed, the cycle will start again from the
same position when it was interrupted and it will be completed.
ASCENT AND DESCENT CYCLE
The pallet is wrapped while the carriage moves up and
down.
At the end of the wrapping cycle the machine automatically stops in the unload position of the
product. When the machine is working in the standard mode, the cycle should not be manually
stopped. Press the STOP button only if you need to stop the cycle for a particular reason. The
cycle will be suspended. When the START button is pressed, the cycle will start again from the
same position when it was interrupted and it will be completed.
DETAILED DESCRIPTION
Press START to start up the automatic wrapping cycle.
The wrapping machine performs the following steps:
a) The table starts to rotate at the speed (C4), the film tension start is set (G12) and the delay
start time (G13) is clocked, after which the film tension is set with the stretch value (C3).
b) Once the low revolutions end (C1), the carriage goes up at the speed (C5)
c) From when the pallet is no longer found, the extra length time is clocked (G10)
d)
After t
he time has elapsed, the carriage stops and waits for the completion of the high
revolutions (C2)
e) The carriage goes down at the speed (C6)
f)
Once it arrives at the limit switch height, the machine automatically looks for the zero
position. The speed set in this last revolution and the reset one (G17) as well as the tension
of the film is set as tension of the last revolution (G14)
g) At the end of the wrapping cycle the machine automatically stops in the unload position of
the product.
CRESCO UCP REV10 22
To Next Page
Loading...
Need help?
General
