Outline of Serial Communications Section 5-1
116
5-1 Outline of Serial Communications
This section explains how to perform serial communications.
Introduction
The CX-Simulator can debugs serial communications using (1) actual com-
munications to an external serial communications device using a COM port
on the computer,(2) screen display of send messages, or (3) input/output
from/to a file.
Note 1. Serial communications cannot be performed when the CX-Simulator is
started and the online connection is made from the CX-Programmer.
2. Refer to 6-3 Serial Communications of CS/CJ Series Programming Manual
for the outline of CS/CJ-series serial communications.
Supported Protocols and Units
The CX-Simulator supports Host Link (SYSMAC WAY), NT Link, and No-
protocol as a protocol for serial communications. These protocols support
differently depending on a Unit that performs serial communications. The re-
lationship between serial communications protocols and Units is shown be-
low.
CPU Unit
Hardware
Protocol
Peripheral port
(Port 1)
RS-232C port
(Port 2)
Serial Com-
munications
Board
Serial Com-
munications
Unit
Host Link
(SYSMAC WAY)
Yes (FINS/C-mode communications)
Protocol macro - No No
NT LInk (1:N mode) Yes (Only Unit No.0 connectable)
No-protocol Yes - -
Peripheral bus No - -
Loopback test
No
-NoNo
Yes: Supported No: Not supported -: Does not exist
Computer
Debu
er: Screen displa
FinsGateway
Simulator
Communi-
cations Unit
CPU
Unit
External
serial com-
munications
device
RS-232C
(1)
(3)
COM
ort
Files
(2)
Virtual Communications Unit
Serial Communications Server
AUDIN - 8, avenue de la malle - 51370 Saint Brice Courcelles - Tel : 03.26.04.20.21 - Fax : 03.26.04.28.20 - Web : http: www.audin.fr - Email : info@audin.fr
To Next Page
Loading...
Need help?
General
