Outline of Operation Procedure Section 3-4
41
Display the contents of serial/network communications to debug with
actual communications.
Refer to 5 Debugging Serial Communications and
6 Debugging Network Communications.
6. Debugging by Virtual External Inputs
6-1 Generating Virtual External Inputs
Create data/program for virtual external inputs.
Refer to 8-3 Generating Virtual External Inputs.
6-2 Virtual Run
Generate virtual external inputs using the created data/program to
virtually run the ladder diagram in more actual way.
Refer to 8-4 Running by Virtual External Inputs.
6-3 Check Results
Check the results of the virtual run by the time chart monitor or
spreadsheet software.
Refer to 8-5 Checking the Result
7. Switching to the actual PLC
Disconnect the Simulator and check the program again with the actual
PLC connected.
3-4-2 Method 2: Starting from the CX-Simulator Menus
1,2,3…
1. CX-Programmer Start
Start the CX-Programmer.
2. Programming
Create a program for debugging by [Create] or by reading an existing
project.
3. CX-Simulator Start
Start the CX-Simulator.
Refer to 3-3 Starting and Exiting from CX-Simulator Menus.
4. PLC Setting Wizard
Select either [Create a new PLC] or an existing PLC directory.
For [Create a new PLC], set as follows.
(1) Select the PLC type.
(2) Select the Units used in PLC.
(3) Set for network communications.
(4) Set for serial communications.
Refer to 3-5 Creating a New PLC.
AUDIN - 8, avenue de la malle - 51370 Saint Brice Courcelles - Tel : 03.26.04.20.21 - Fax : 03.26.04.28.20 - Web : http: www.audin.fr - Email : info@audin.fr
To Next Page
Loading...
Need help?
General
