Outline of Operation Procedure Section 3-4
42
5. Connecting with CX-Programmer
CX-Programmer Version 3.0
a) Select [Automatically Transfer Program to Simulator] on the [PLCs] tab
under [Tool] | [Option].
b) Select [Simulator Online Connection] from the [PLC] menu.
c) Click the [OK] button on the dialog box for the program transfer option.
Refer to 3-2 Starting and Going Online from the CX-Programmer.
CX-Programmer Version 2.1
Exiting the PLC Setup wizard will start the Ladder Engine according to the
setting. Also, each window for Connect to Simulator, Debug Console, and
System Status Setting is displayed. First, select a communications path
(unit) in the [Connect to CX-Simulator] window. Second, press the [Con-
nect] button to check the FINS destination address of the Ladder Engine
displayed in the Connection Guidance.
Refer to 3-8 Connecting to the CX-Programmer Version 2.1 or Lower.
6. CX-Programmer Communications Setting
Set the communications setting for the PLC simulated by the CX-
Programmer according to the communications unit and the FINS address
checked in the [Connect to CX-Simulator] window.
Refer to 3-8 Connecting to the CX-Programmer.
7. PLC Online Connection
Select [Work Online] by the CX-Programmer. When completing online
connection, turn the mode of the Ladder Engine to PROGRAM.
8. Program Download
Download the program from the CX-Programmer to the CPU Unit of the
Ladder Engine in the PROGRAM mode (remain unchanged).
Refer to the CX-Programmer Operation Manual.
9. Trial Run
Either turning the mode of the Ladder Engine to MONITOR by the CX-
Programmer or pressing the [Continuous Run] button of the [Debug Con-
sole] leads to a trial run.
Refer to the CX-Programmer Operation Manual.
AUDIN - 8, avenue de la malle - 51370 Saint Brice Courcelles - Tel : 03.26.04.20.21 - Fax : 03.26.04.28.20 - Web : http: www.audin.fr - Email : info@audin.fr
To Next Page
Loading...
Need help?
General
