5 - 59
5 Advanced Operations
E5@C Digital Temperature Controllers User’s Manual (H174)
5-19 Displaying PV/SV Status
5
5-19-1 PV and SV Status Display Functions
Note: The default is OFF.
* Selection is possible only with the E5DC, E5DC-B and E5GC. (The E5DC must be manufactured in July
2014 or later (version 2.2 or higher).)
Example: When ALM1 Is Selected for the SV Status Display Function
Priority of Flashing and Alternating Displays on No. 2 Display
The priority for flashing and alternating displays is as follows:
(1) Alternating display with SV status display
(2) Alternating display during program end output
Set value Display Function
OFF off No SV status display
Manual manu MANU is alternately displayed during manual control.
Stop stop STOP is alternately displayed while operation is stopped.
Alarm 1 alm1 ALM1 is alternately displayed during Alarm 1 status.
Alarm 2 alm2 ALM2 is alternately displayed during Alarm 2 status.
Alarm 3 alm3 ALM3 is alternately displayed during Alarm 3 status.
Alarm 4 alm4 ALM4 is alternately displayed during Alarm 4 status.
Alarm 1 to 4 OR status alm ALM is alternately displayed when Alarm 1, 2, 3, or 4 is set to ON.
Heater Alarm ha HA is alternately displayed when an HB alarm or HS alarm is ON.
Status display mes-
sage* wr
While one or more of the work bits (WR1 to WR8) is ON, the message
for the highest bit number that is ON is alternately displayed with the
corresponding bit number.
The following procedure sets the PV Status Display Function parameter
to ALM1.
Operating Procedure
1
Press the M Key several times in the Advanced Function Set-
ting Level to display pvst (PV Status Display Function).
Advanced Function Setting
Level
2
Press the U or D Key to select alm1 (alarm 1).
The default is off.
3
If the Alarm 1 status is ON in Operation Level, the PV and alm1
(Alarm 1) will be alternately displayed.
Operation Level
100
alm1
25
100
25
When ALM1 Is ON
Normal
PV/SP
Alternating
display
off
pvst
PV Status
Display Function
alm1
pvst
To Next Page
Loading...
Need help?
General
