6 Parameters
6 - 2
E5@C Digital Temperature Controllers User’s Manual (H174)
6-1 Conventions Used in this Section
Meanings of Icons Used in this Section
About Related Parameter Displays
Parameters are displayed only when the conditions for use given on the right of the parameter
heading are satisfied. Protected parameters are not displayed regardless of the conditions for use,
but the settings of these parameters are still valid.
The Order of Parameters in This Section
Parameters are described level by level.
The first page of each level describes the parameters in the level and the procedure to switch
between parameters.
Alarms
It will be specified in this section when alarms are set for the Control Output 1 or 2 Assignment
parameters, or for the Auxiliary Output 1 to 4 Assignment parameters. For example, when alarm 1 is
set for the Control Output 1 Assignment parameter, it will be specified that alarm 1 is assigned.
Assigning a work bit to either control output 1 or 2 or to auxiliary output 1 to 4 is also considered to
be the same as assigning an alarm. For example, if work bit 1 is set for the Auxiliary Output 1
Assignment parameter, then alarms 1 to 4 have been assigned.
Describes the functions of the parameter.
Describes the setting range and default of the parameter.
Used to indicate parameters used only for monitoring.
Describes the parameter settings, such as those for Operation Commands, and
procedures.
Used to indicate information on descriptions in which the parameter is used or the
names of related parameters.
Function
at
AT Execute/Cancel
The E5@C must be in operation, and control
must be 2-PID control.
Displayed symbol Parameter name Conditions for use
To Next Page
Loading...
Need help?
General
