23. Do not accidentally press touch switches when the backlight is not lit or when the display
does not appear.
24. Signals from the touch switches may not be input if the switches are pressed
consecutively at high speed. Confirm each input before proceeding to the next one.
25. Before initializing screen data, confirm that existing data is backed up at the CX-Designer.
26. When changing the password with the system menu, do not reset or turn OFF the power
supply until writing is finished (i.e., until the Write Button returns to its original condition). It
may become impossible to manipulate screens if the password is not set correctly.
27. When using the device monitor, confirm the safety of the system before performing the
following operations.
•
•
•
•
Changing monitor data
Changing operation modes
Forced setting or resetting
Changing present values or set values
28. Do not use benzene, paint thinner, or other volatile solvents, and do not use chemically
treated cloths.
29. Dispose of any battery that has been dropped on the floor or otherwise subjected to
excessive shock.
30. Do not attempt to disassemble, repair, or modify the Unit in any way.
31. Dispose of the Units and batteries according to local ordinances as they apply.
To ensure system safety, incorporate a program that periodically accesses PT operation bits
from the host side and check to confirm that the PT is properly operating.
32. Do not connect an USB connector to any device that is not applicable.
33. Before connecting an USB connector to a device, make sure that the device is free of
damage.
34. When mounting the Battery, be sure to use the correct Battery and mount it correctly.
35. The backlight in the NS-series PT contains mercury. Do not dispose of the PT together
with waste to be processed at disposal plants. Dispose of the PT according to all local
laws, regulations, and ordinances.
12
To Next Page
Loading...
Need help?
General
