6-3 PT Settings
6-3-1 Start-up Wait Time
The start-up wait time refers to the waiting time before the PT starts communicating with the
host after the PT power is turned ON or the PT is reset Set the system startup waiting time
when the host requires time before it starts running.
The setting range is between 0 and 10 s and the default is 0 s.
Set the system startup waiting time by using operations from the PT Tab Page in the System
Menu, as follows:
1. Set the waiting time in the Start-up Wait Time field in second units.
Input the value in the dialog box that is displayed by pressing the setting input column.
2. After setting, press the Write Button to save the setting.
Reference
• Nothing is displayed during the system startup waiting time.
• The system startup waiting time is calculated from when initialization finishes.
Therefore, if the startup waiting time is set to 0 s, the PT will not start actual commu-
nications with the host immediately after the power is turned ON.
6-3-2 Screen Saver
To extend the life of the backlight, the screen saver function turns OFF the screen display
when operations are not performed for a fixed period of time.
The default setting is for no screen saver.
The time before the screen saver function is activated can be set in one-minute units between
1 and 255 minutes. The default setting is 15 min.
Set the screen saver movement by using operations from the PT Tab Page in the System
Menu, as follows:
6-21
To Next Page
Loading...
Need help?
General
