4 Handling and Installation Environment
4 - 4
Vision System FH/FZ5 series Hardware Setup Manual (Z366)
4-2 FH-1000/FH-3000 Series
Precautions for Correct Use
Ambient Temperature
• Install and store the product in a location that meets the following conditions:
• Surrounding temperature of 0 to 50°C (-20 to +65°C in storage)
• Relative humidity of between 35 to 85%RH
• Do not let the ambient temperature exceed 50°C (122°F).
• Provide a forced-air fan cooling or air conditioning if the ambient temperature is near 50°C
(1
22°F) so that the ambient temperature never exceeds 50°C (122°F).
Orientation of Product
• For good heat dissipation, install the product only in the position shown below so as not to
blo
ck the ventilation holes.
• Do not install the product in the following positions
.
• For good ventilation, provide a clearance of 50
mm or more above the sensor controller away
from other devices in the normal floor mounting. For the right and left sides, provide a clear-
ance of 30 mm or more, and for the back side, 15 mm or more. These clearances are also
r
equired when mounting multiple sensor controllers side by side. For the back mounting, the
back-side clearance of 15 mm is nor required.
Handling a SD memory card
• Before removing SD memory card, make sure that data is not being read or written to it.
• Do not insert an SD memory card in the reverse
orientation, at an angle, or in a twisting man-
ner.
• For an SD memory card, the SD BUSY LED of Sensor Controller flashes while data is being
r
ead or written.
Make sure that the LED stops flashing before removing the card.
To Next Page
Loading...
Need help?
General
