Omron SYSMAC FH Series Hardware Setup Manual

5 Setup and Wiring
5 - 34
Vision System FH/FZ5 series Hardware Setup Manual (Z366)
5-6 Insert SD Memory Card or USB memory
Precautions for Correct Use
When removing USB memory
• Confirm the SD memory card of USB memory is not in running, and then remove it.
• Before removing a USB memory device or SD memo
ry card, make sure that data is not being
read or written to them.
• When a message is displayed indicating that a task is in progress, do not turn OFF the
po
wer.
• Do not insert or remove USB memory during measurement, loading, and writing.
There is the possibility of measurement time or
damage of data.
• When you connect the USB memory using USB hub, the
drive name after launching can be changed.
If you want to ensure the drive name does not change, connect to the USB port directly without using
USB hub.
Precautions for Correct Use
Handling of SD memory card
• When you touch a terminal part of SD memory card, antistatic is required by using a wrist
strap or others.
• Do not insert an SD memory card in the reverse
orientation, at an angle, or in a twisting man-
ner.
Removing SD memory card
• Before removing a SD memory card, make sure that d
ata is not being read or written to them.
• For an SD memory card, the SD BUSY LED of Sensor Controller flashes while data is being
r
ead or written.
Make sure that the LED stops flashing before removing the card.
• When a message is displayed indicating that a task is in progress, do not turn OFF the
po
wer.
Do not insert or remove SD memory card during measurement, loading, and writing.
There is the possibility of measurement
time or damage of data.
Additional Information
For external memory device, refer to the Using External Memory Devices in Vision System
FH/FZ5 Series User’s Manual (Cat. No. Z365).
5-6-1 FH-1000/FH-3000 Series

Omron SYSMAC FH Series Specifications

General

Brand	Omron
Model	SYSMAC FH Series
Category	Industrial Equipment
Language	English