Onkyo A-9130 User Manual

10
Preparations
a Analog Audio Cable
Use an Analog audio cable to connect a player to one of the
LINE IN 1/2/3/4/5 jacks. Refer to "Connecting with Onkyo RI
Components" (p11) to use the RI function.
a Analog Audio Cable
Use an analog audio cable to connect a turntable that uses
an MM-type cartridge to the PHONO (MM) jack.
If the turntable has a ground wire, connect it to the GND
terminal. With some turntables, connecting the ground wire
may cause hum, in which case it should be disconnected.
0 If the turntable has a built-in audio equalizer, connect it to
an LINE IN jack other than the PHONO (MM) jack. Also, if
the turntable uses an MC type cartridge, install an audio
equalizer compatible with the MC type cartridge between
the unit and the turntable, then connect to any LINE IN
jack other than the PHONO (MM) jack.
Connecting players (LINE IN
connection)
a
a
CD
Tuner
Connecting players (Turntable
connection)
a
Turntable
SN29403409_A-9130_En_1806XX.book 10 ページ ２０１８年７月１２日 木曜日 午後８時４５分

Onkyo A-9130 Specifications

Audio Specifications

rated output power	60 W at 4 ohms, 20 Hz-20 kHz
dynamic power	260 W (3 ohms, Front)
input sensitivity and impedance	200 mV/47 kohms (LINE (RCA))
frequency response	10 Hz - 100 kHz
signal to noise ratio	106 dB (IHF-A, LINE IN, SP OUT)
speaker impedance	4 ohms - 16 ohms

Power

power supply	AC 220-230 V, 50/60 Hz
power consumption	150 W
standby power consumption	0.2 W

Weight and Dimensions

dimensions	435 mm x 129 mm x 330 mm
dimensions (inches)	17-1/8" x 5-1/16" x 13"
weight	8.0 kg (17.6 lbs)