Onkyo A-9130 User Manual

20
Others
When automatic standby is on (default value), the unit
automatically switches to standby mode after 20 minutes of
no audio input without any operations.
1. Press SETUP on the remote controller.
0 If this unit is set to be used as a power amplifier, the
SETUP button will not work. Check the setting. (p19)
2. Press D/C on the remote controller several times to
make the "DIRECT" and "PHASE MATCHING BASS"
indicators either blink or light.
0 The indicators blink or light and the current setting
value is displayed.
3. Press B/A on the remote controller to switch auto
standby on or off.
-On (default value): "DIRECT" and "PHASE MATCHING
BASS" indicators are blinking
-Off: "DIRECT" and "PHASE MATCHING BASS"
indicators light
4. To exit the settings, press SETUP.
0 The setting mode ends after 5 seconds elapse with no
operations performed.
0 60 seconds before switching to standby mode, the input
source indicator for the currently selected source starts
blinking.
0 Depending on the connected device, the auto standby
feature may not engage due to factors such as noise.
Useful functions
Setting auto standby
(LIGHTING)
OFF
(BLINKING)
ON
3
1
2
SETUP
///
SN29403409_A-9130_En_1806XX.book 20 ページ ２０１８年７月１２日 木曜日 午後８時４５分

Onkyo A-9130 Specifications

Audio Specifications

rated output power	60 W at 4 ohms, 20 Hz-20 kHz
dynamic power	260 W (3 ohms, Front)
input sensitivity and impedance	200 mV/47 kohms (LINE (RCA))
frequency response	10 Hz - 100 kHz
signal to noise ratio	106 dB (IHF-A, LINE IN, SP OUT)
speaker impedance	4 ohms - 16 ohms

Power

power supply	AC 220-230 V, 50/60 Hz
power consumption	150 W
standby power consumption	0.2 W

Weight and Dimensions

dimensions	435 mm x 129 mm x 330 mm
dimensions (inches)	17-1/8" x 5-1/16" x 13"
weight	8.0 kg (17.6 lbs)