EasyManuals Logo
Home>Onkyo>Receiver>TX-NR708

Onkyo TX-NR708 User Manual

Onkyo TX-NR708
96 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #21 background imageLoading...
Page #21 background image
21
En
This section explains how to connect the supplied indoor FM antenna and AM loop antenna.
The AV receiver won’t pick up any radio signals without any antenna connected, so you must connect the antenna to use
the tuner.
Note
Once your AV receiver is ready for use, you’ll need to tune into a radio station and position the antenna to achieve the best possible
reception.
Keep the AM loop antenna as far away as possible from your AV receiver, TV, speaker cables, and power cords.
Tip
If you cannot achieve good reception with the supplied indoor FM antenna, try a commercially available outdoor FM antenna instead.
If you cannot achieve good reception with the supplied indoor AM loop antenna, try using it with a commercially available outdoor AM
antenna.
Note
Before connecting the power cord, connect all of your speak-
ers and AV components.
Turning on the AV receiver may cause a momentary power surge
that might interfere with other electrical equipment on the same
circuit. If this is a problem, plug the AV receiver into a different
branch circuit.
Do not use a power cord other than the one supplied with the AV
receiver. The supplied power cord is designed exclusively for
use with the AV receiver and should not be used with any other
equipment.
Never disconnect the power cord from the AV receiver while the
other end is still plugged into a wall outlet. Doing so may cause
an electric shock. Always disconnect the power cord from the
wall outlet first, and then the AV receiver.
Connecting Antenna
Connecting the Power Cord (European, Australian and Asian models)
Thumbtacks, etc.
Insert the plug fully
into the jack.
Insert the plug fully
into the jack.
(North American and
Taiwan models)
(European, Australian
and Asian models)
Push.
Assembling the AM loop antenna.
Indoor FM antenna (supplied)
AM loop antenna (supplied)
Caution
Be careful that you don’t injure yourself when
using thumbtacks.
Insert wire. Release.
Step 1:
Connect the supplied power cord to the AV receiver’s
AC INLET.
Step 2:
Plug the power cord into an AC wall outlet.
To AC wall outlet

Table of Contents

Other manuals for Onkyo TX-NR708

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Onkyo TX-NR708 and is the answer not in the manual?

Onkyo TX-NR708 Specifications

Power IconPower
power supplyAC 220–240 V~, 50/60 Hz
power consumption570 W
dynamic power (3 Ω)250 W
dynamic power (4 Ω)220 W
dynamic power (8 Ω)130 W
Amplifier Specifications IconAmplifier Specifications
power output (front L/R)170 W/Ch (6 Ω, 1 kHz, 1 channel driven, IEC)
power output (center)170 W (6 Ω, 1 kHz, 1 channel driven, IEC)
power output (surround L/R)170 W/Ch (6 Ω, 1 kHz, 1 channel driven, IEC)
thd (total harmonic distortion)0.08% (Rated power)
damping factor60 (Front, 1 kHz, 8 Ω)
Audio Specifications IconAudio Specifications
input sensitivity and impedance (line)200 mV/47 kΩ
input sensitivity and impedance (phono MM)2.5 mV/47 kΩ
frequency response5 Hz–100 kHz/+1 dB, -3 dB (DSP bypass)
tone control (bass)±10 dB, 50 Hz
tone control (treble)±10 dB, 20 kHz
Video Specifications IconVideo Specifications
video input sensitivity/output level and impedance (component and S-Video Y)1.0 Vp–p/75 Ω
video input sensitivity/output level and impedance (component PB/CB, PR/CR)0.7 Vp–p/75 Ω
video input sensitivity/output level and impedance (S-Video C)0.25 Vp–p/75 Ω
video input sensitivity/output level and impedance (composite)1.0 Vp–p/75 Ω
component video frequency response5 Hz–100 MHz/0 dB, -3 dB
Tuner Specifications IconTuner Specifications
tuning frequency range (fm)87.5 MHz–108 MHz
tuning frequency range (am)522 kHz–1, 611 kHz
fm/am preset memory40 stations
Weight and Dimensions IconWeight and Dimensions
weight12.5 kg
dimensions435 x 175 x 379 mm
carton dimensions570 x 298 x 469 mm
carton weight16.5 kg

Related product manuals