8
Do not press the reset button again unless you want to completely remove all your
programming.
Turn the rotary dial to the time/date position.
12:00 AM will appear in the display with three arrows pointing to the year,
month, and day [See Figure 3].
Press and hold the + button to advance the clock to the correct time of day.
Use the – button to go in reverse. When the correct time of day is reached,
press the enter button to lock in the time.
To increase or decrease more rapidly, hold down either the + or – buttons until the
display goes into rapid advance mode.
A blinking cursor will appear below the arrow for the year, month, and date
when programming.
Use the + and – buttons to set the correct year, then press enter.
Use the + and – buttons to set the correct month, then press enter.
Figure 3: LCD Display with Surrounding Information
To Next Page
Need help?
General