14
Press and hold the + or - keys to select the number of days between watering.
(Example: If you want to water once every 10 days, set the interval at 10.)
To activate the watering interval, press Enter. (Example: If an interval of "3" is
entered today, the timer will water for the first time today, and then again
every "3" days.)
To select odd or even day watering, press next. The cursor will move to either
the odd or even setting, then press enter.
To erase a schedule, press Clear. To enter a new schedule, press Next.
Reviewing and Changing Your Program
The Orbit timer lets you easily review a complete watering schedule. To review
Program A watering start times, simply turn the rotary dial to the Start Times
position in Program A and check the times that have been entered. Using the
next key, you may advance through the schedule without fear of disturbing any
programming.
If you want to change the start times, watering days, or interval, simply follow the
directions for that program. After reviewing or changing a watering schedule,
remember to turn the rotary dial back to Auto if you want the timer to automatically
follow the program.
Ready for Automatic Operation
After programming is complete, turn the rotary selector to Auto [See Figure 8]. The
timer is now fully programmed and ready to use in the automatic mode. In automat-
ic mode, each station will operate sequentially, starting with Program A.
To Next Page
Loading...
Need help?
General