Advanced (Recording pictures)
- 84 -
Note
• Do not turn the camera off or remove the card after recording until the access indication
lights off.
• The Burst speed becomes slower halfway. The exact timing of this depends on the type
of card, the picture size and the quality.
• The focus is xed when the rst picture is taken.
• The exposure and the White Balance are adjusted each time you take a picture.
• When the self-timer is used, the number of recordable pictures in Burst Mode is xed to
3.
• The Burst speed (pictures/second) may become slower depending on the recording
environment such as in dark places, if the ISO sensitivity is high etc.
• Burst Mode is not canceled when the camera is switched off.
• If you take pictures in Burst Mode with the built-in memory, it will take time to write the
picture data.
• [o] is set for the ash when burst is set.
• You cannot use Burst Mode in following conditions.
– In [Panorama Assist], [Hi-Speed Burst], [Flash Burst], [Starry Sky], [Fireworks],
[Pin Hole] and [Photo Frame] in Scene Mode
– When recording motion pictures
[Color Mode]
For details on [Rec] Mode menu settings, refer to P39.
Using these modes, the pictures can be made sharper or softer, the colors of the pictures
can be turned into sepia colors or other color effects can be achieved.
Applicable modes: 4 1 6
[STD.] (standard) / [Happy]
(brightness and vividness) / [NAT] (soft) / [VIVID] (sharp) /
[B/W] (black and white) / [SEPIA] (sepia) / [COOL] (more blue) / [WARM] (more red)
¼
[Happy] can be set only when using Intelligent Auto Mode.
Note
• In Intelligent Auto Mode, only [STD.], [Happy], [B/W] and [SEPIA] can be set.
• If picture noise is noticeable in dark locations, set to [NAT].
To Next Page
Loading...
Need help?
General
