18 R eference & Installation Manual
5.3 PGM Ba se Tim e
SECTION [006]: O PT ION [3]
If the keypad's on-board PGM is set in PGM Timed Mode (see
section 5.2 on page 17) you must define whether the value
programmed in section [008] is in minutes or seconds.
5.4 PGM Override
SECTION [006]: O PT ION [4]
When the PGM override is enabled, the keypad's on-board PGM
will ignore PGM Ac tivation Events (section section 5.6 on page
19, page 19), PGM Deactivation Events (section section 5.7 on
page 19, page 19), and PGM Timers (section section 5.5 on
page 18, page 18). It will remain in its normal state until the PGM
Override is disabled. This option may be used to test the PGM
connections.
5.5 PGM Timer
SECTION [008]
If the keypad's on-board PGM is in PGM Timed Mode, the value
programmed in section [008] represents how long the PGM will
remain in its opposite state (see section 5.1 on page 17) after
being activated. To program the timer, enter a 3-digit decimal
Option [3] OFF = PGM Base Time is 1 second (default).
Option [3] ON = PGM Base Time is 1 minute.
Option [4] OFF = PGM Override disabled (default).
Option [4] ON = PGM Override enabled.
To Next Page
Loading...
Need help?
General
