6 Reference & Installation Manual
3.0 Programming
To program the DGP2-641 keypad, enter Module Programming
Mode and then enter the desired section followed by the required
data. When programming the keypad, use the keypad’s
programming sheets (found in the Digiplex/DigiplexNE Modules’
Programming Guide) to keep track of which sections were
programmed and how. We strongly recommend you read this
entire manual before you begin programming.
The LCD keypad can also be programmed using the WinL oad
Security System Management Software. For more information,
refer to the WinLoad instructions or visit our Web site at
www.paradox.ca.
3.1 Entering Module Programming Mode
The keypad, like all other modules in the system , is programmed
through the control panel. To do so, you must first enter Module
Programming Mode:
1. Fro m Norma l Mode pr e ss an d h o ld th e [0] key.
2. E nt er the [INSTALLER CODE] (by default 000000).
3. Ent er section [953] (DGP-48) / [4003] (DGP-NE96).
4. E nt er the ke yp ad’s 8 -d igit [SERIAL NUMBER].
5. Enter the 3-digit [SECTION] you want to program.
6. Enter the required [DATA].
The control panel will then redirect all programming to the
selec ted keypad. Every time the [CL EA R ] key is pressed it will
revert to the preceding step, unless entering in data in which
To Next Page
Loading...
Need help?
General
