USER MANUAL
Peplink Balance Series
http://www.peplink.com - 69 - Copyright © 2010 Peplink
13 Inbound Access
Inbound Access is also known as inbound port address translation. On NAT WAN connection, all inbound
traffic to the server behind Peplink unit requires Inbound Access rules.
By the custom definition of servers and services for inbound access, Internet users can access the
servers behind Peplink Balance. Advanced configurations allow inbound access to be distributed among
multiple servers on the LAN.
Important Note
Inbound Access applies only to WAN connections that operate under NAT mode. For WAN connections that
operate under drop-in mode or IP forwarding, inbound traffic is forwarded to the LAN by default.
13.1 Definition of Servers on LAN
The settings to configure servers on the LAN are located at the following location: Network > Inbound
Access > Servers
To define a new server, click Add Server, upon which the following screen appears:
Enter a valid server name (should be consisted of alphanumeric and the underscore “_” characters only),
and the corresponding LAN IP address.
Upon clicking Save after entering required information, the following screen appears.
To define additional servers, click Add Server and repeat the above steps.
To Next Page
Loading...
Need help?
General
