peplink 210 User Manual

USER MANUAL
Peplink Balance Series
http://www.peplink.com - 7 - Copyright © 2010 Peplink
3 Product Features
Peplink Balance Series products enable all LAN users to share broadband Internet connections, and
provide advanced features to enhance Internet access. The following is the list of supported features:
3.1 Supported Network Features
3.1.1 WAN
 Multiple public IP support (DHCP, PPPoE, Static IP Address, or GRE)
 10/100/1000 Mbps Connection in Full/Half Duplex (1000 Mbps Connection is available only
with Peplink Balance 390, 580, 710 and 1350)
 USB Mobile Connection (available only with Peplink Balance 380, 390, 580, 710 and 1350)
 Drop-in Mode on selectable WAN port with MAC address passthrough
 Network Address Translation (NAT) / Port Address Translation (PAT)
 Inbound and Outbound NAT mapping
 IPsec NAT-T and PPTP packet passthrough
 Multiple static IP addresses per WAN Connection
 MAC address clone
 Customizable MTU and MSS values
 WAN connection health check
 Dynamic DNS (Supported service providers: changeip.com, dyndns.org, no-ip.org and tzo.com)
3.1.2 LAN
 DHCP server on LAN
 Static routing rules
 Local DNS
3.1.3 VPN
 Secure Site-to-Site VPN
 VPN load balancing and failover among selected WAN connections
 Site-to-Site VPN bandwidth bonding
 Ability to route Internet traffic to a remote VPN peer
 PPTP server
 PPTP and IPsec passthrough
3.1.4 Firewall
 Outbound (LAN to WAN) firewall rules
 Inbound (WAN to LAN) firewall rules per WAN connection
 Intrusion detection and prevention
 Specification of NAT mappings
3.1.5 Inbound Traffic Management
 TCP/UDP traffic redirection to dedicated LAN server(s)
 Inbound link load balancing by means of DNS

peplink 210 Specifications

General

Brand	peplink
Model	210
Category	Wireless Router
Language	English