166
Safety
ISOFIX mountings
Your vehicle has been approved in accordance
with the latest ISOFIX regulations.
The seats, shown below, are fitted with ISOFIX
compliant mountings:
There are three rings for each seat:
This ISOFIX mounting system provides fast,
reliable and safe fitting of the child seat in your
vehicle.
ISOFIX child seats are fitted with two latches
which are secured on the two rings A.
Some seats also have an upper strap which is
attached to ring B.
To secure the child seat to the TOP TETHER:
F remove and stow the head restraint before
installing the child seat on the seat (refit it
once the child seat has been removed),
When fitting an ISOFIX child seat to the
left-hand rear seat, before fitting the
seat, first move the centre rear seat belt
towards the middle of the vehicle, so
as to avoid the seat interfering with the
operation of the seat belt.
The incorrect installation of a child seat
in a vehicle compromises the child's
protection in the event of an accident.
Strictly follow the fitting instructions
provided in the user guide supplied with
the child seat.
For information on the possibilities for
installing ISOFIX child seats in your
vehicle, refer to the summary table.
F pass the upper strap of the child seat behind
the seat backrest, between the apertures
for the head restraint rods,
F fix the hook of the upper strap to ring B,
F tighten the upper strap.
- two rings A, located between the vehicle's
seat backrest and cushion, indicated by a
marking,
- a ring B, located behind the seat and
identified by a marking, for securing the
upper strap, referred to as Top Tether.
To Next Page
Loading...
Need help?
General
