284
In the event of a breakdown
Changing a wiper blade
Before removing a front
wiper
Removing
F Lift the corresponding wiper arm away from
the windscreen.
F Unclip and remove the wiper blade.
Refitting
F Position and clip the new wiper blade to the
arm.
F Carefully lower the wiper arm.
After refitting a front wiper
F Switch on the ignition.
F Operate the wiper control stalk again to
park the wiper blades.
Changing a fuse
Replacing a fuse
Before replacing a fuse:
F the cause of the failure must be identified
and rectified,
F all electrical consumers must be switched
off,
F the vehicle must be immobilised with the
ignition off,
F identify the defective fuse using the existing
allocation tables and diagrams.
To replace a fuse, you must:
F use the special tweezers to extract the fuse
from its housing and check the condition of
its filament.
F always replace the failed fuse with a fuse
of the same rating (same colour); using a
different rating could cause faults (risk of
fire).
If the fuse fails again soon after replacement,
have the vehicle's electrical system checked by
a PEUGEOT dealer or a qualified workshop.
F Within one minute after switching off the
ignition, operate the wiper control stalk to
position the wiper blades in the middle of
the windscreen (maintenance position).
To Next Page
Loading...
Need help?
General
