Adjustment
14 - 28
14.29 Cold start
When a cold start is carried out, the seam patterns 50 – 99 and all altered
parameter settings are deleted! The machine is reset to its condition on
delivery, the machine’s zero points remain unaffected.
● Switch on the machine.
● Select parameter "607" with the corresponding plus/minus keys.
● If necessary, enter the code, see Chapter 11.04.01 Entering the access code in the
instruction manual.
● With the corresponding plus/minus key
carry out the reset operation.
● Switch the machine off and on again after approx. 3 seconds.
To Next Page
Loading...
Need help?
General
