Adjustment
14 - 38
ERROR: 301 Raise clamp not completed
ERROR: 302 Lower clamp not completed
ERROR: 303 Raise clamp locked (needle position)
ERROR: 304 Lower clamp locked (needle position)
ERROR: 305 Thread wiper on locked (needle position)
ERROR: 401 Error sewing motor
ERROR: 402 Overload data transfer sewing motor
ERROR: 403 Program station not programmed
ERROR: 404 Program locked
ERROR: 405 Program does not exist
ERROR: 406 No NIS
ERROR: 407 Zero points invalid
ERROR: 408 Machine not in basic position
ERROR: 409 Zero point not found
14.33 Sewing motor errors
1 Time out
9 Position not reached
34 Brake path too short
35 Communication error
36 Initialisation (Init.) not completed
65 Extint low at Init
66 Short circuit
68 Extint low in operation
69 No increments
14.34 OTE-errors
1 Read error
2 Write error
3 Full EEPROM
4 No EEPROM
5 Invalid size
6 Invalid address
7 Address overflow
8 Checksum falled
9 Serialnr. changed
70 Motor blocking
71 No incremental connector
73 Motor running interrupted
75 Controller locked
170 Invalid transmission
171 Zero mark invalid
175 Start error
222 Time-out monitoring
(Sewing head recognition unit)
To Next Page
Loading...
Need help?
General
