01_08
Maintenance icons (01_08)
At vehicle ignition, immediately after the ignition check, if there are less than 300 km
to the next scheduled service, the corresponding icon flashes for 5 seconds. Once the
scheduled service mileage is reached, the icon remains lit until the execution of the
scheduled service.
01_09
*MODE* button (01_09, 01_10)
Pushing the MODE button «A» for less than a second displays the following sequence
of functions:
•
Total Odometer «ODO»
•
Partial Odometer «ODO I»
•
Partial Odometer «ODO II»
•
State of battery charge
•
Ambient temperature «°»
To reset the trip odometer, move «ODO I» or «ODO II» and press for more than three
seconds the button MODE «A».
01_10
UNIT OF MEASUREMENT SETTING
When using the function measuring the voltage of the battery, holding down the
MODE button for longer than 10 seconds will switch between reading in kilometres or
miles for the odometer. For the first 5 seconds the display will not give any signal, for
the next 5 seconds the message unit of measurement (Km or mi) currently in use will
blink at a frequency of one flash per second. If the button is released before 10 seconds
the measurement unit is not changed.
14
To Next Page
Loading...
Need help?
General
