03_24
Braking system fluid top up (03_24)
Proceed as follows:
Loosen the two fixing screws «A» and remove the cap to perform the top-up to the
recommended level exclusively with recommended fluids without exceeding the max-
imum level.
This procedure applies to the rear brake pump top-up operation; follow the same pro-
cedure for the front brake pump.
Under standard climatic conditions, replace fluid as indicated in the scheduled main-
tenance table.
This operation must be carried out by trained personnel; take your vehicle to an au-
thorised Service centre or Dealer.
WARNING
ONLY USE DOT 4 CLASS BRAKE FLUIDS. BRAKING CIRCUIT FLUIDS ARE
HIGHLY CORROSIVE. MAKE SURE THAT IT DOES NOT COME INTO CONTACT
WITH THE PAINTWORK
.
CAUTION
AVOID CONTACT OF BRAKE FLUID WITH EYES, SKIN, AND CLOTHING. IN
CASE OF CONTACT, RINSE WITH WATER. THE BRAKING CIRCUIT FLUID IS
HYGROSCOPIC, THAT IS, IT ABSORBS HUMIDITY FROM THE SURROUNDING
AIR. IF THE HUMIDITY IN THE BRAKING FLUID EXCEEDS A CERTAIN VALUE,
IT WILL LEAD TO INEFFICIENT BRAKING. NEVER USE BRAKING FLUID KEPT
IN CONTAINERS THAT HAVE ALREADY BEEN OPENED, OR PARTIALLY USED.
Recommended products
AGIP BRAKE 4
59
To Next Page
Loading...
