Removing the driven pulley shaft bearing
- Remove the Seeger ring.
CAUTION
PLACE THE COVER ON A SURFACE, REMOVING OR EX-
CLUDING THE ALIGNMENT DOWELS.
- Using the housing to support the cover of the
transmission, interpose a few layers of heavy cloth
so as not to damage the outer surface of the cover.
- Using appropriate tools, remove the bearing.
Specific tooling
020376Y Adaptor handle
020358Y 37 x 40 mm Adaptor
020439Y 17-mm guide
001467Y002 Driver for OD 73 mm bearing
Refitting the driven pulley shaft bearing
- Use the heat gun to heat the inner part of the lid.
CAUTION
DO NOT HEAT EXCESSIVELY SO AS NOT TO DAMAGE
THE PAINTWORK.
Specific tooling
020151Y Air heater
Using the equipment, mount a new bearing, apply
grease on the adapter and on the guide in order to
maintain the position of the bearing during opera-
tion on the vertical axis.
Specific tooling
020376Y Adaptor handle
020358Y 37 x 40 mm Adaptor
020439Y 17-mm guide
MP3 400 hpe E5 Engine
ENG - 39
To Next Page
Loading...
Need help?
General