# The larger the setting number, the higher the
signal level. The highest level setting allows re-
ception of only the strongest stations, while lower
settings let you receive progressively weaker
stations.
Using iTunes tagging
This function can be operated with the following
iPod models.
— iPhone 4
— iPhone 3GS
— iPhone 3G
— iPhone
— iPod nano 5th generation
— iPod 5th generation
— iPod nano 4th generation
— iPod nano 3rd generation
— iPod touch 2nd generation
— iPod touch 1st generation
— iPod classic 2nd generation
— iPod classic
However, tag information can be stored in this
unit even while other iPod models are used.
When you want to use this function in the HD
Radio tuner sour ce, use an HD Radio tuner
(GEX-P20HD).
The song informatio n (tag) can be saved from
the broadcasting station to your iPod. The
songs will show up in a playlist called “Tagged
playlist” in iTunes the next time you sync your
iPod. Then you can directly buy the songs you
want from the iTunes Store.
The tagged songs and the song that you can
buy from the iTunes Store may be different.
Make sure to confirm the song before you
make the purchase.
If you cannot use this function normally, up-
date your iPod firmware.
Storing the tag information to
this unit
1 Tune in to the broadcast station.
2 Store the tag information to this unit.
Refer to Introduction of tuner operations on
page 17.
Refer to Introduction of HD Radioä tuner opera-
tions on page 31.
You can store the information if the TAG indi-
cator is displayed while the desired song is
being broadcast.
# While storing the tag data on this unit, TAG
flashes.
# The tag information for up to 50 songs can be
stored on this unit.
Depending on the timing of when the tag infor-
mation is stored, the tag information for the song
played before or after the currently playing song
may also be stored.
# If an SD is selected as the source while tag in-
formation is being stored to this unit, the tag in-
formation will not be transferred to the iPod.
3 When completed, indicator turns
off and
indicator is displayed.
Storing the tagged information
to your iPod
1 Connect your iPod if it's not connected
to this unit.
When your iPod is connected to this unit, your
iPod starts storing the tagged information
automatically.
# While transferring the tag, you cannot select
the SD source.
2 When completed, indicator on page
93 turns off and the tagged information is
stored on your iPod.
# Tag information cannot be transferred to the
iPod when a file on an SD device is being viewed
as a slideshow.
<QRB3126-A/N>36
En
36
Section
14
Detailed instructions
To Next Page
Loading...
Need help?
General
