Appendix
ltC_A_d_d_i_t-io_n_a_l-in_f_o_r_m_a_t-io_n
__________________________
)
Troubleshooting
Common
Symptom
Cause
Action
(Refer-
ence
page)
The
power will
not turn on.
The
unit will
not operate.
Leads and con- Confirm
once more
nectars are incor- that
all
connec-
rectly connected. tions are correct.
The
fuse is
blown.
Rectify the cause
and then replace
the fuse.
Be
sure to
install a fuse with
the same rating.
Operation with Battery power
is
Load
a new battery.
the remote
low.
control is not
possible.
The
unit does
not operate
correctly
even
when the
ap-
propriate
re-
mote control
buttons are
pressed.
Playback
is
not
possible.
There
is
no
sound.
The
volume
level
will not
rise.
There is no
image dis-
played.
®En
Some operations
Try
operating with
are prohibited another disc.
with certain
discs.
The
disc
is
dirty.
Clean
the disc.
The
type of disc
Check
the disc
loaded cannot
be
type.
played on this
unit.
The
disc loaded Change
the disc to
is
not compatible
one
that
is
compa-
with this video tible
with your
system.
video system.
Cables
are not
Connect
the cables
connected cor- correctly.
rectly.
The
unit
is
per- There
is
no sound
forming still,
during
still, slow
slow
motion
or
motion or frame-
frame-by-frame
by-frame playback.
playback.
The
parking
Connect
the park-
brake cable is
ing brake cable,
not connected.
and
apply
the park-
ing brake.
The parking
Connect
the park-
brake
is
not
ap-
ing brake cable,
plied.
and
apply
the park-
ing brake.
Symptom
Cause
Action
(Refer-
ence page)
The
<S)
icon is The operation
is
This operation
is
not possible.
displayed, and prohibited for the
operation is not disc.
possible.
-Th-e-op_e_r-at-io_n_i_s--Th_i_s_o-pe-r-at-io-n-is--
The
image dis-
played stops
(pauses) and
the unit cannot
be
operated.
There is no
sound.
The
volume
level is
low.
The
sound and
video skip.
The
aspect
ratio
is
incor-
rect and the
image is
stretched.
The
motor
sounds when
the ignition
switch is
turned
ON
(or
is turned to
ACC).
Nothing
is
dis-
played.
The
touch
panel
keys
can-
not
be
used.
not compatible not possible.
with the config-
uration of the
disc.
The data could
Stop playback
no longer
be
once, and start
read during
play-
playback again.
back.
The volume level
is low.
The
attenuator is
on.
The unit is not
firmly secured.
File
size
and
transmission rate
are above recom-
mended rates.
The aspect ratio
setting is incor-
rect for the dis-
play.
The unit is con-
firming whether
or
not a disc
is
loaded.
The rear view
camera
is
not
connected.
Adjust the volume
level.
Turn
the attenuator
off.
Firmly secure the
unit.
Create
a
DivX
file
that
is
within the
recommended
size
and transmission
rate.
Select the appro-
priate setting for
your display.
(Page
61)
This
is
a normal
operation.
Connect
a rear
view camera.
Camera
Polarity
Press
and
hold
is at incorrect
HOME
to return to
setting. the source display
and then select the
correct setting for
Camera
Polarity.
(Page
67)
To Next Page
Loading...
Need help?
General
