9.16
BRAKES
REAR CALIPER SERVICE
Caliper Exploded View
Caliper Removal
1. Elevate and safely support the rear of the vehicle.
2. Remove the (4) wheel nuts and rear wheel.
3. Clean caliper area before removal.
4. Place a container below the caliper to catch the brake fluid
when removing the line. Remove brake line from caliper.
5. Loosen the brake pad adjustment set screw to allow brake
pad removal after the caliper is removed.
6. Remove the two caliper mounting bolts and remove the
caliper.
A. Brake Pad
B. Mount Bracket
C. Piston
D. Caliper Assy.
E. Square Ring (thick)
F. Square Ring (thin)
G. Boot, Pin Bushing
H. Boot, Pin Seal
I. Bleeder Screw
K. Set Screw
A
B
C
D
E
F
G
H
I
K
Apply Polaris DOT 4 Brake Fluid
to Component
Apply Polaris All Purpose
Grease
47 in. lbs.
(5.3 Nm)
CAUTION
Use care when supporting vehicle so that it does not
tip or fall. Severe injury may occur.
Remove
Brake Line
Remove
To Next Page
Loading...
Need help?
General
