To Next Page

To Previous Page

5.34

BODY / SUSPENSION / STEERING

9923983 - 2012-2013 RZR 170 Service Manual

Wheel Installation

1. Verify the parking brake is still engaged.

2. Install the wheel hub, washer(s), and castle nut, if

previously removed.

3. Place the wheel in the correct position on the wheel

hub. Be sure the valve stem is toward the outside and

rotation arrows on the tire point toward forward

rotation.

4. Attach the wheel nuts and finger tighten them.

5. Carefully lower the vehicle to the ground.

6. Torque the wheel nuts and/or hub nut to the proper

torque specification.

7. If hub nut was removed, install a new cotter pin after

the hub nut has been tightened.

= T

Wheel Nuts:

27 ft-lbs (37 Nm)

= T

Front Hub Castle Nut:

40 ft-lbs (55 Nm)

= T

Rear Hub Castle Nut:

40 ft-lbs (55 Nm)

CAUTION

If wheels are improperly installed it could affect

vehicle handling and tire wear. On vehicles with

tapered rear wheel nuts, make sure tapered end

of nut goes into taper on wheel.

Polaris RANGER RZR 170 Service Manual

Questions and Answers: