7.6
CVT / TRANSMISSION
9923983 - 2012-2013 RZR 170 Service Manual
© Copyright 2012 Polaris Sales Inc.
6. Install battery tray panel, rear access panel, and
seats.
Drive Belt Removal
1. Remove CVT cover. See “Clutch (CVT) Cover
Removal / Inspection” on page 7.5
2. Pull moveable (outer) sheave of driven out and push
belt as far down as possible to create belt slack.
3. Remove drive clutch nut (A). Use a strap wrench to
hold stationary sheave.
4. Hold inner (moveable) sheave (B) inward when
removing belt from drive clutch to prevent rollers from
falling out of the clutch ramps. Remove belt from
driven clutch.
Drive Belt Inspection
1. Inspect surface of drive belt for uneven wear or
grease deposits. Measure width. Replace belt if worn
or glazed.
Drive Belt Installation
1. Do not attempt to install drive belt with drive clutch
stationary sheave installed.
2. Push moveable sheave and spacer sleeve of drive
clutch fully inward and measure the amount of
exposed splines on the shaft. Be sure at least 5/16
(mm) of spline is exposed. If less than 5/16 is
exposed, remove clutch and sleeve and check
assembly of components.
CVT Drive Belt Width
Service Limit: .626” (15.9mm)
To Next Page
Loading...
Need help?
General
