3.27
ENGINE
3
9923983 - 2012-2013 RZR 170 Service Manual
© Copyright 2012 Polaris Sales Inc.
3. If the installed gap measurement exceeds the limit,
replace the rings. If using new rings and the
measurement is too small, file the ring ends to achieve
the proper gap.
NOTE: Always check piston ring installed gap after
re-boring a cylinder or when installing new rings. A
re-bored cylinder should always be scrubbed
thoroughly with hot soapy water, rinsed, and dried
completely. Wipe cylinder bore with an oil rag
immediately to remove residue and prevent rust.
BOTTOM-END DISASSEMBLY
Starter Drive Gear Removal and Inspection
1. Remove the fan from the hub.
2. Remove the fan hub by removing the flywheel nut,
washer and pulling the hub from the crankshaft.
3. Remove stator housing bolts and remove housing.
To Next Page
Loading...
Need help?
General
