7.5
CVT / TRANSMISSION
7
9923983 - 2012-2013 RZR 170 Service Manual
© Copyright 2012 Polaris Sales Inc.
Clutch (CVT) Cover Removal / Inspection
1. Refer to Chapter 5 to remove the seats, rear access
panel, and battery tray panel to access the CVT
cover.
2. Remove duct mounting screws (A). Loosen duct
clamps (B) and slide both ducts off cover.
3. Remove (8) cover screws. Tap cover to loosen.
4. Pull cover out until disengaged from dowel pins. Tip
bottom of cover up to clear fuel tank.
5. Carefully guide cover to clear shift cables and tank.
6. Inspect bearing (C). It should rotate freely without
binding. Replace if rough, if inner race is loose, or if
bearing is loose in the cover. Be sure screws for air
duct plate (D) are tight.
Clutch (CVT) Cover Installation
1. Clean gasket surfaces and install a new gasket with
cover alignment dowels (E) in place.
2. Install drive and driven clutch with belt. Refer to clutch
installation this chapter.
3. Guide cover through cables and tip in same manner
as for removal in order to clear fuel tank.
4. Install cover and tighten all screws to specified torque.
5. Connect inlet and exhaust air ducts (F) with clamps.
A
B
36 in-lb.
25 in-lb.
(2.8 Nm)
(4.0 Nm)
To Next Page
Loading...
Need help?
General
