6.26
BRAKES
9923983 - 2012-2013 RZR 170 Service Manual
© Copyright 2012 Polaris Sales Inc.
NOTE: Dispose of fluid properly. Do not re-use.
5. Remove clip (C) and disconnect brake actuator rod
clevis from brake pedal.
6. Remove the two mounting fasteners (D) that secure
the master cylinder to the frame.
Installation
1. Reverse Steps 1-5 for master cylinder installation.
Refer to the torque specifications in the removal
steps. Install new sealing washers on brake lines.
2. After installing the master cylinder, perform the
following:
• Fill the reservoir with Polaris Dot 4 Brake Fluid (PN
2872189) from a new, sealed container.
• Bleed the master cylinder and both front and rear
brake lines and calipers.
See “BRAKE BLEEDING
/ FLUID CHANGE” on page 6.7.
• Inspect pedal free play and pedal travel. See
“Brake Pedal Inspection / Adjustment” on
page 6.9.
• Test brake system for proper function before
returning the vehicle to service.
A
B
15 in-lb. (1.7 Nm)
14.5 ft-lb. (19.6 Nm)
To Next Page
Loading...
Need help?
General
