Polaris RZR XP 1000 2014 Service Manual

5.34
9926816 R07 - 2014-2016 RZR XP 1000 / XP4 1000 Service Manual
© Copyright Polaris Industries Inc.
10.Turn clutch sheave counterclockwise until bushing is
removed and sheave comes free.
11. Remove nut (left hand thread) from puller rod and set
aside.
12.Remove adapters from puller.
13.Remove bushing and removal tool from adapters.
Discard bushing.
CLUTCH BUSHING INSTALLATION
1. Install Number Two Puller Adapter
a
onto puller.
2. Install the Adapter Reducer
o
onto puller.
3. Apply Loctite® 648 evenly to bushing bore inside
moveable sheave.
4. Install sheave face down on puller.
5. Install new bushing on installation tool
w
and install
assembly into sheave.
6. Install left hand thread nut onto puller rod and hand
tighten against installation tool.
7. Turn clutch sheave counterclockwise, making sure
bushing is drawn straight into bore. Continue until
bushing is seated.
8. Remove nut from puller rod and set aside.
9. Remove installation tool and clutch sheave from
puller.
DRIVEN CLUTCH ASSEMBLY
1. Install a new bearing
q
onto the clutch shaft using an
arbor press. Once bearing is fully seated, install a
new snap ring
w
.
PVT SYSTEM

Polaris RZR XP 1000 2014 Specifications

General

Brand	Polaris
Model	RZR XP 1000 2014
Category	Offroad Vehicle
Language	English