8.22
9926816 R07 - 2014-2016 RZR XP 1000 / XP4 1000 Service Manual
© Copyright Polaris Industries Inc.
STABILIZER BAR REMOVAL
1. Lift and support vehicle by main frame.
2. Remove rear wheels nut and wheels.
3. Identify / mark top side of the stabilizer bar to
reference during installation.
4. Remove the fasteners retaining the stabilizer bar to
the linkage
q
on each side of the vehicle.
5. Remove the four fasteners
w
retaining the stabilizer
bar to the vehicle frame.
6. Remove the bushing brackets and bushings for ease
of removal.
7. Carefully remove the stabilizer from the LH wheel
well area of the vehicle.
8. Inspect the stabilizer bar for straightness. Inspect the
pivot bushings and replace if needed.
STABILIZER BAR INSTALLATION
1. Carefully install stabilizer bar through the LH wheel
well area.
NOTE
Be sure fuel lines and shift cable are routed ABOVE the
stabilizer bar.
2. Fully install stabilizer bar, bushings, bracket and
bracket fasteners and stabilizer links. Center
stabilizer bar in the frame. Torque fasteners to
specification (see below).
3. Torque all fasteners to specification (see below).
4. Lubricate stabilizer bar pivot bushings via grease
fitting (fittings are accessible through skid plate).
5. Install rear wheels and wheel nuts. Torque wheel
nuts to specification.
TORQUE
Rear Stabilizer Bar Linkage:
40 ft-lbs (54 Nm)
Wheel Lug Nuts:
120 ft-lbs (163 Nm)
STEERING / SUSPENSION
To Next Page
Loading...
Need help?
General
