Administrator’s Guide for the VSX Series
4 - 44
Configuring Directory Settings
You can customize the behavior of the directory on the Directory screen.
To configure system settings:
1. Go to System > Admin Settings > General Settings > System Settings >
Directory.
2. Configure these settings:
Points to note about cascaded calls:
• You cannot place cascaded multipoint calls through PathNavigator.
• Polycom StereoSurround, Pro-Motion, AES encryption, continuous presence,
chair control, People+Content, and H.239 are not supported in cascaded calls.
• H.264 is only supported when all of the MCUs are VSX 8000 systems and each
VSX 8000 calls no more than three other systems.
Setting Description
System Name Enter or change the system name in this field. This name
appears on the screen for the far site when you are making
calls.
Localized System
Name
Displays the localized system name, if you have entered
one. You can enter a Localized System Name for
Simplified Chinese on this screen using the Chinese Virtual
Keyboard. You must use the VSX Web interface to enter
localized system names for other languages.
The localized system name is sent to the far site and
displayed as the caller ID by VSX systems using version 8.0
or later, when the user interface is set to that language.
However, the English/Pinyin name is the name used by the
Global Directory Server and the gatekeeper, and it is also
the name that shows up in the Recent Calls list.
Allow Directory
Changes
Specifies whether users can save changes they make to the
directory.
Confirm Directory
Additions Upon
Call Disconnect
Specifies whether users are prompted to confirm new
directory entries when saving the information for the last site
called.
Confirm Directory
Deletions
Specifies whether users are prompted to confirm deletions
of directory entries.
To Next Page
Loading...
Need help?
General
