Configuring Network Use
3 - 21
Configuring the PRI Network Interface
To use the PRI network interface, you must configure the following:
• PRI network support
• PRI channels
• PRI information
Your ISDN service provider can tell you which protocol your network uses. If
you later change the Country setting, the PRI switch protocols available may
also change, and you may be prompted to configure a different PRI switch
protocol.
To configure the ISDN network interface settings:
1. Go to System > Admin Settings > Network > ISDN.
2. Configure these settings:
Points to note about fractional PRI:
• Assigned channels must begin with channel 1, and the channel numbers must
be consecutive.
• A D channel must be provided.
• Outbound call bandwidth must not exceed the available bandwidth.
Setting Description
Enable ISDN
H.320
Allows this system to make H.320 (ISDN) calls.
Area Code Specifies the area code for this system’s location.
PRI Video
Number
Specifies the ISDN number assigned to this system.
Outside Line
Dialing Prefix
Specifies the ISDN dialing prefix used to call outside the
network.
BONDING:
Calling Endpoint
Uses the Original
ISDN Number
Specifies the use of a bonding standard. Incoming bonded
calls will use the original number received to connect all
remaining lines required for the call.
To Next Page
Loading...
Need help?
General
