3 - 1
3
Configuring Network Use
This chapter lists the information you need to get your network ready for
video conferencing. Once you’ve gathered that information, you can begin
configuring the system’s network options. Details on how to perform this
configuration are also included in this chapter.
When you power on your system for the first time, the setup wizard detects
the system’s IP and ISDN connections and leads you through the minimum
configuration steps required to place a call.
If you need to change any of the initial settings to accommodate your
organization’s environment, you can manually adjust them using the screens
described in this chapter.
Note that if you establish an administrator’s password during the setup
wizard, you will need to enter it each time you wish to change administrative
settings.
Getting the Network Ready
Before you begin configuring the network options, you must make sure your
network is ready for video conferencing.
To begin, refer to the Preparing Your Network for Collaboration document,
available at www.polycom.com/videodocumentation. This document
contains information you need to prepare your network, such as worksheets
that will help you order ISDN.
To Next Page
Loading...
Need help?
General
