Matrix User Guide
Page 18 RINS915-2
4.2 LCD Keypad
4.2.1 Arming – Single Partition User
If all zones are closed the OK LED will be illuminated.
Otherwise use the
& buttons to list the open zones.
The open zones will be displayed in order on the display:
Enter you personal user code
to arm the panel.
The partition will start arming in mode A and a repeated high tone counting the exit time will be emitted from the
keypad.
If a different Arm Mode is desired press then or or
or .
TIME/DATE
ARM MODE B
Leave the premises by the designated route.
Depending on the programming and arm mode used, you may be required to press a ‘Push To Set’ button
before the system will fully arm.
4.2.2 Displaying the Armed Status – Single Partition User
Once the system is armed the LCD keypad will either display the time/date and the arm mode (A, B, C or D) or
it will just the time and date. This depends on how the Matrix features have been programmed by your installer.
4.2.3 Disarming – Single Partition User
Enter you personal user code
.
No Alarm Condition
If your code has been accepted, you will hear a confirmation tone and the system will disarm. The LCD keypad
will revert to normal day mode operation.
After Alarm Condition
If your code has been accepted, you will hear a confirmation tone and the system will go into First To Alarm
(FTA) mode.
To Next Page
Loading...
Need help?
General
